Rockford Fosgate Punch P500X1bd Mono subwoofer amplifier — 500 watts RMS x 1 at 1 ohm + P2D2-10 Punch P2 10" subwoofer with dual 2-ohm voice coils

General Features:

P500X1BD

• mono subwoofer amplifier
• 150 watts RMS x 1 at 4 ohms (300 watts RMS x 1 at 2 ohms)
• 500 watts RMS x 1 at 1 ohm
• CEA-2006 compliant
• Features:
• variable low-pass filter filter (50-250 Hz, 12 dB/octave)
• selectable subsonic filter (28Hz, 12 dB/octave)
• variable PEQ2 bass boost (0-18 dB at 45 Hz)
• C.L.E.A.N. gain setup system includes clip lights and link to Rockford Fosgate's setup tones
• Class-BD amplifier design
• frequency response: 20-250 Hz
• Dynamic Thermal Management and MEHSA MOSFET cooling systems
• MOSFET power and output stages
• preamp inputs and outputs
• speaker-level inputs (speaker wire to RCA adapter required)
• signal-sensing turn-on with speaker-level inputs eliminate need for remote turn-on lead

More Info:

• optional PLC2 wired remote level control with clip light available
• 4-gauge power and ground leads and an 80-amp fuse recommended — wiring and hardware not included with amplifier
• no onboard fuses — when installing multiple amps in a system, an additional 80-amp in-line fuse between the distribution block and the amplifier is recommended
• 11-1/8"W x 2-7/16"H x 8-13/16"D

P2D2-10

• 10" subwoofer with dual 4-ohm voice coils
• Kevlar® reinforced paper cone
• Santoprene surround
• hybrid StampCast basket provides strength while minimizing weight and resonance
• power range: 75-300 watts RMS (600 watts peak power)
• frequency response: 31-250 Hz
• sensitivity: 84 dB
• top-mount depth: 5-15/16"
• sealed box volume: 0.5-0.85 cubic feet
• ported box volume: 1.4 cubic feet
• grille not included

Standout performance

Rockford Fosgate showcases their fanatical commitment to sonic excellence in the Punch Series of speakers, amps, and subs. If you like to listen to potent, powerful music — and feel it too — Punch components will give you impressive sound that'll stand out in a crowd.

Bulletproof bass

Engineers at Rockford Fosgate designed the P2D2-10 10" subwoofer to dish out the kind of powerful low end you crave in your ride. Its responsive paper cone is reinforced with the same Kevlar® fibers used in bulletproof vests so you get the best of both worlds — warm bass that's exceptionally hard-hitting. Rockford Fosgate uses a new technique to attach the oversized rubber surround to the cone that increases available cone area up to 25%, so this sub can push more air for even bigger bass.

Made for heavy excursion

This P2 sub features an extended pole piece and bumped backplate that leaves more room for heavy excursion, so it'll hit deeper lows without "bottoming out." Special venting keeps the copper-clad aluminum voice coils cool through heavy use for consistent bass performance over time.

The dual 2-ohm voice coils allow you to wire the sub for 1-ohm impedance to get maximum power output, or for 4-ohm impedance if you're using multiple subs. The P2D2-10 sub works equally well in a sealed or ported enclosure, so you can choose the kind of bass you want for your system.