General Features:

• 10” Optical Bonded HD Display
• Wireless Apple CarPlay Ready
• Wireless Android Auto Ready
• iDatalink Maestro APX Ready (Maestro included)
• Android Auto & Apple CarPlay Split Screen
• Pitch & Roll Widget and Source
• Modular Chassis Design
• Rear USB Type-C (3A/15W Fast Charge)
• Included GPS Antenna for Mapping
• Bluetooth Wireless Technology
• USB Audio Formats (MP3/WMA/AAC/WAV/FLAC)
• USB Video Formats (MPEG 1-2/MPEG 4/H.264/MKV/WMV)

• 3-Way Crossover Mode
• SiriusXM 360L Ready (satellite radio tuner and antenna sold separately)
• Time Alignment
• 13-Band Graphic EQ & Parametric EQ
• Preset EQ Options
• Front/Rear/Sub Preouts - 4V
• Rear Video Output
• Rear A/V Input26
• Multilingual Display (English/French/Spanish)
• Steering Wheel Remote Ready (ADSMRR2 included)
• Gesture Touch Control

iDatalink Maestro APX-FL-FO1 Dash & Wiring KitInstall Direct Replacement receivers with a 10" screen in select 2011-23 Ford vehicles with 4" MyFord Touch radios

• allows you to install a Kenwood or JVC Direct Replacement radio with a 10.1" floating screen in select 2011-23 Ford vehicles with factory 4" MyFord Touch radio 
• retains appearance of factory dash
• provides 12V/15A accessory power and illumination outputs
• provides outputs (parking brake, reverse, vehicle speed sensor [VSS]) needed to install a navigation or multimedia receiver
• retains the following factory features (if present):
  • steering wheel audio controls with two function buttons and expandable radio functions
  • backup camera with dynamic parking guidelines and park assist chimes
  • factory 360° camera (if equipped)
  • secondary vehicle display (if factory equipped)
  • factory climate display/controls and vehicle settings from head unit's screen
  • USB port
  • warning chimes
• adds these features:
  • display vehicle information
  • selectable performance gauges including "Track Pack" gauges
  • read/reset check engine codes

iDatalink Maestro RR2 Interface ModuleConnect a new stereo and retain the steering wheel audio controls and other factory features in select vehicles

• allows installation of your new car stereo
• the module will need to be loaded with correct firmware before installation (must be done by your installer at the time of installation)
• works with required vehicle-specific harness to retain factory steering wheel audio controls, retain the factory amp if present, and integrate all car stereo connections
• retains factory convenience features (OnStar, SYNC, Uconnect, and more) with select iDatalink-ready receivers
• displays engine performance data on touchscreen with select iDatalink-ready receivers
• setup via Bluetooth-enabled device or mini-USB-to-USB-A cable
• three programmable outputs control relay-driven aftermarket accessories
• dedicated port connects to select Escort radar detectors (sold separately)
• dimensions: 4-3/4"W x 3/4"H x 3-1/4"D

iDatalink Maestro ACC-HU-KEN1 adapter

Includes the iDatalink ACC-HU-KEN1 adapter harness which allows for direct connection between the radio and compatible iDatalink Maestro vehicle specific harnesses used with the iDatalink Maestro ADS-MRR2 radio replacement interface module. The ACC-HU-KEN1 adapter harness will replace the wiring harness that comes with your JVC radio. There is a 22-pin Kenwood/JVC connector on one end that plugs into the back of your JVC radio and a 20-pin iDatalink Maestro connector on the other end that will plug into a compatible iDatalink Maestro vehicle specific harness. The 22-pin Kenwood/JVC connector features the following wiring pinout.